Home Automation Lighting & LED Drivers
Drivers, dimmers, remotes and smart scenes.
- 4.4★ on Google
- BIS-certified range
- Trade orders welcome
Home automation lighting lets you dim, change colour and set scenes from a remote, a wall switch or your phone. We stock MASCON LED drivers, dimmers, BLE remotes, scene switches, DALI drivers and a gateway hub, and offer end-to-end automation, from our Periyamedu showroom.
What does an LED driver do?
It turns 220V mains into the low voltage your LEDs need, usually 12V, 24V or 48V. A good driver also stops flicker.
How do you choose the right driver?
Voltage
Match the strip or track: 12V, 24V or 48V.
Wattage
Add up the lights, then leave some headroom.
Location
Use a waterproof driver outdoors or in damp areas.
Dimmers, remotes and scenes
Dimming
Turn lights down for the evening.
Tunable white
Shift from warm to cool with one remote.
Scenes
One tap for "Movie", "Dinner" or "All off".
App control
Through the gateway hub.
Questions people ask
Strips, profiles and magnetic tracks do. Many downlights have one built in.
Only if the driver supports dimming. Bring the model number and we'll check.
A driver that talks to a control system, so each light can be dimmed and grouped individually.
Yes, through a gateway hub with compatible drivers.
Usually a weak or wrong driver, or a dimmer that doesn't match the driver. Replacing the driver often fixes it.
Light that can shift between warm and cool white from one remote, like the Lucchino spotlight.
It depends on the number of circuits and the system. A single room with dimming costs far less than a whole-house setup.
BLE remotes and scene switches work without it. App control usually runs through a gateway hub on your home network.
A wall switch with preset buttons, like "Dinner" or "Movie", that sets several lights at once.
Yes. A strip controller with a BLE or RF remote handles dimming and, on RGB strips, colour.
The lights on it go out, or start to flicker. Replace the driver with one of the same voltage and enough wattage.
Good to know before you buy
Decide on controls before wiring
Scene switches, DALI and smart hubs need the right wiring from the start. Talk to us before the electrician lays the cables, not after.
Keep drivers reachable
Drivers are the part most likely to need replacing. Place them in a false-ceiling access panel or a cabinet, never sealed in plaster.
Choose the right driver for outdoors
Outdoor and damp areas need a waterproof driver, like the Candy W/P. A standard driver in a wet spot will fail early.
Start simple
Dimming in the living room and bedroom gives the biggest difference for the least cost. Add scenes and app control later if you want them.
Common mistakes to avoid
Not every LED driver can be dimmed, and not every dimmer works with every driver. A mismatch causes flicker and buzzing. Check both before buying.
When a driver fails, it has to come out. Keep every driver behind an access panel.
If it fails, the whole room goes dark. Split large installations across a few drivers.
Scene and smart systems need the right cables in the right places. Plan them before the electrician starts.
Two remotes and an app for one room is frustrating. Pick one system per space.
